Techneglas
Technical Products
2100 N. Wilkinson Way
Perrysburg, OH 43551 |
| I.
Product Information |
Product Name:
BoronPlus® (GS126, 93XX; GS-139, 90XX; GS-183, 91XX;
GS-245, 92XX; GS-278, 94XX)
Synonyms: Boron Solid Diffusion Source
Chemical Family: Mixture
Chemical Formula: N/A
CAS Number: N/A
DOT Shipping Number: N/A
DOT Shipping Name: Other Ceramic Articles
DOT Hazard Class: N/A
EPA Hazardous Waste ID Number: D005
|
| II.
Chemical Ingredients |
| (*)
Listed under Section 313 of Title III (SARA) |
Name |
Percentage |
ACGIH-TLV
(mg/m3) |
OSHA-PEL
(mg/m3) |
Barium
Oxide |
8.0%
- 12.0%* |
0.5 |
0.5 |
Silicon
Dioxide |
31.0%
- 39.0%* |
0.100
(Quartz) |
0.25
(Respirable)**
0.74 (Total)** |
Boron
Oxide |
19.0%
- 36.0%* |
10 |
15
(Total) |
Aluminum
Oxide |
20.0%
- 35.0%* |
10 |
5
(Respirable)
15 (Total) |
Magnesium
Oxide
(Fume) |
1.5%
- 2.5%* |
10 |
15
(Total) |
*Percentages
will vary between the five different BoronPlus®
products
**PEL calculated using 38.4% SiO2 (i.e. worst case scenario)
TLV and PEL are listed as time weighted averages (TWA)
unless otherwise notes. |
| III.
Physical Properties |
Boiling Point:
N/A
Melting Point: N/A
Vapor Pressure (mmHg): N/A
Solubility in Water: N/A
Vapor Density (Air =1): N/A
Specific Gravity: >1.0
Percent Volatile by Volume: N/A
pH: N/A
Appearance & Odor: White solid,
no odor. |
| IV.
Reactivity Data |
Stability: Stable
Incompatible Materials: None
Hazardous
Decomposition Products: N/A
Hazardous
Polymerization: Will not occur.
Conditions
to Avoid: N/A |
| V.
Fire and Explosion Data |
Flash Point:
N/A
Lower Explosive Limit: N/A
Upper Explosive Limit: N/A
Extinguishing Media: Select for surrounding
materials.
Special Firefighting Procedures:
Wear pressure demand self-contained breathing apparatus
in conjunction with appropriate personal protective
equipment.
Unusual Fire and Explosion Hazards:
This product is non-combustible.
|
| Back
to top |
| VI.
Health Hazard Information |
Primary Routes of Exposure:
Inhalation.
Signs and Symptoms of Overexposure:
Overexposure is only possible if the material is ground
into finely divided particles and suspended in air.
Under these conditions, upper respiratory congestion,
dyspnea, chest pain, cough, and decreased vital capacity
or progressive fibrosis may result.
Medical Conditions Aggravated by Exposure:
: Prolonged or repeated exposure may aggravate pre-existing
respiratory or cardiovascular system conditions.
Listing as a Carcinogen:
This material is not listed as a carcinogen by the
NTP, IARC, or OSHA. This material contains silicon
dioxide, which is listed as a carcinogen by the NTP,
IARC, and OSHA. Signs and symptoms described above
are based on silicon dioxide exposure.
|
| VII.
Emergency First Aid Procedures |
Inhalation:
Remove to fresh air. Seek medical attention, if necessary.
Ingestion: Consult physician immediately.
Eye Contact:
Immediately flush eyes for 15 minutes with large amounts
of water, occasionally lifting upper and lower eyelids.
If irritation persists, seek medical attention.
Skin Contact: Wash the affected area
with soap and water. Seek medical attention if irritation
persists.
|
| VIII.
Control Measures |
Engineering Controls:
General ventilation recommended under normal conditions
of use. If active dust and/or fume generation occurs,
local ventilation is recommended.
Work/Hygiene Practices: Avoid inhalation
of dusts and/or fumes. If necessary, wear NIOSH/MSHA
approved respiratory protection for dusts, mists,
or fumes.
Personal Protective Equipment:
Respiratory Protection:
If necessary, wear NIOSH/MSHA approved respiratory
protection for dusts, mists, and fumes.
Eye/Face Protection: Recommended.
Skin Protection: Recommended to
prevent skin irritation.
|
| IX.
Storage and Disposal Information |
| Spill or Leak Procedures:
Clean up spilled material into a closed container using
a high efficiency vacuum. Avoid dust generation.
Disposal Methods:
Dispose of in accordance with local, state, or federal
regulations.
Handling and Storage
Precautions: Store in a cool, dry location.
|
| X.
Manufacturer/Supplier Information |
Prepared by: Terry
Richardson
Date: Aug 21, 2006
Revision Date: Aug 21, 2006
24-Hour Emergency Telephone Number:
614-443-6551
General Information Number: 419-873-2000
Manufacturer’s Contact: Bill
Blessing
CHEMTREC: (U.S.) 800-424-9300
(Int’l) 703-527-3887
|
| Back
to top |
